I used the In Bloom PTI stamp Set to make this card.
The base card was such a pretty Aqua colour that I used the left over pieces to stamp the sentiment, flowers and leaves onto and didn't need to colour them at all.
I took a square of white card slightly smaller than the base card and stamped the largest flower all over the card in black ink, tied a matching ribbon around this then stuck it onto the base card leaving the aqua border showing.
I cut out the sentiment, flowers and leaves and attached them to the card with foam pads then a couple of pearls and a little bit of stickles and I was done.
Attention to detail...
A dot of stickles glitter glue was added to the centre of each flower and the the veins of the leaves to make them pop.